EAQE Passing Score
The published EAQE pass mark is 60% in each part during the same sitting.
- Part I is worth 60 marks, so the minimum is 36.
- Part II is worth 40 marks, so the minimum is 24.
- A total of 60 or more does not pass if either part falls below its own threshold.
On this page7 sections
- Part I
- 60 marks; at least 36 to pass
- Part II
- 40 marks; at least 24 to pass
- Overall
- At least 60 marks, subject to both part thresholds
- Sitting rule
- Both parts must be passed in the same examination
- Penalty condition
- Where a mark penalty applies, at least 60% overall after deduction is also required
The pass mark has two thresholds
The Estate Agents Authority’s current published rule requires EAQE candidates to pass both Part I and Part II in the same examination. The pass mark is 60%. Part I carries 60 marks and needs at least 36; Part II carries 40 marks and needs at least 24. Because both thresholds apply, you cannot use surplus marks in one part to make up for a shortfall in the other.
| Result pattern | Part I result | Part II result | Outcome under the published rule |
|---|---|---|---|
| A | 38 of 60 | 25 of 40 | Meets both thresholds and totals 63 |
| B | 48 of 60 | 22 of 40 | Does not pass: Part II below 24 |
| C | 35 of 60 | 31 of 40 | Does not pass: Part I below 36 |
| D | 36 of 60 | 24 of 40 | Meets each minimum, subject to applicable rules |
The examples use the part marks published by the EAA. They show why “60 overall” is an incomplete shorthand. Candidate B earns 70 marks in total but misses the Part II minimum by two. Candidate C earns 66 but misses Part I by one. A candidate preparing from an overall mock score alone may miss a weakness that determines the official outcome.
How the marks relate to the paper
Part I contains 30 stand-alone multiple-choice questions and is worth 60 marks. Part II contains 20 questions based on one or two case studies and is worth 40 marks. The paper lasts three hours. The EAA publishes the total marks for each part and the minimum marks needed to pass them, but readers should not assume every question has the same mark value unless the examination instructions say so.
The candidate-facing implication is to track performance by part and by type of reasoning. A practice log might show Part I accuracy and case-study accuracy separately, then break errors into rule knowledge, fact selection, interpretation of documents, calculations or careless reading. The EAA does not publish an official formula for mapping practice questions to an exam score, so such a log is a diagnostic tool rather than a prediction.
If you use a practice resource with equal marks per item, label that scoring as the resource’s method. Do not present it as an official reproduction of the EAQE’s marking scheme. For example, a mock with 30 stand-alone items and 20 case items may be close in format but still have its own scoring assumptions. The EAA’s official threshold remains part-specific marks, not a percentage from an unrelated question bank.
Why Part II can make the difference
Part II places multiple questions beside a shared case. A candidate may know an individual legal rule yet miss marks by overlooking a date, confusing the client and counterparty, or treating an agent’s assumption as verified property information. Practice should therefore make the case-reading step explicit. Before answering, identify who each person is, which agreement or document appears, what happened first, and what was known at the relevant time.
Consider a case in which a vendor’s estate agency agreement sets a fixed list price and an agent later advertises a lower figure after a buyer requests it. One question may ask about the advertisement; another may ask about the agent’s duty to relay an offer. The same case calls for different rules. Answering both from the broad idea of “act in the client’s interest” is not enough. Locate the prescribed requirement that controls each action.
Use a missed Part II question to identify the exact reasoning break. Did you fail to notice the date, infer a term absent from the signed agreement, or extend a land-search record beyond the information it contains? Repairing that step can improve several questions across a case. Rereading whole chapters after every case error is less efficient than tracing the decision back to the fact and rule.
Mark penalties and the overall result
The current handbook describes possible mark penalties when a candidate contravenes an examination regulation. If such a penalty is imposed, the candidate still has to pass both parts and must also obtain an overall pass mark of 60% after deduction. The ordinary part minima remain essential, and a penalty can make an otherwise narrow overall score insufficient.
This rule is not a reason to calculate a speculative buffer or invent a penalty scale. The handbook does not give candidates a universal penalty amount to apply to every conduct problem. Read the current Instructions to Candidates, follow the permitted materials and answer-sheet rules, and do not communicate or engage in conduct that could result in sanctions.
The EAA notes that the published pass mark is subject to review. Candidates should check the EAA website for an announcement of any change. An old set of notes that says “60%” should not be the only source used to confirm the requirement for a future sitting, even though the official materials checked here still list 60%.
Set a sensible practice threshold
A mock score is most useful when it reports both parts independently. If your Part I average is consistently above 36 but Part II is near 24, prioritize case reading and rule application rather than polishing already stable stand-alone recall. If Part II is strong but Part I fluctuates, review short definitions, regulatory responsibilities and distinctions that appear in isolated questions.
A practice buffer can help account for uncertainty, but there is no officially prescribed buffer above the published minima. You can set a personal target above 36 and 24 for rehearsal, then explain why the target fits your current performance. Avoid describing that target as the EAA’s standard. Report what it is: a preparation benchmark you selected to reduce the risk of sitting at the threshold.
When reviewing an answer, write down marks lost and the source that resolves the issue. If a legal rule changed after an old sample question was published, update the note from the current authority. The EAA explicitly warns that sample questions and reference materials may not cover the full syllabus and that law and practice can change. Source checking improves the quality of practice and helps keep a mock result in perspective.
Use score reports for diagnosis
The thresholds are stated in marks, while the paper is often casually described as a 60-percent exam. Keep the denominators visible: Part I is 60 marks and Part II is 40. For a candidate reviewing a mock, write the marks beside each part. A percentage can conceal which threshold was missed, especially if a preparation resource uses the same percentage display for both sections.
EAA says it may review the pass mark and announce changes on its website. For a future sitting, check the exam page close to registration and again before the exam. If a revised threshold is announced, update all study materials and practice calculations. A cached handbook can define a past sitting accurately and still be the wrong final source for a later examination.
Interpret marks and statistics separately
The official statistics table records the pass rate and participant numbers for the EAQE separately from the part thresholds. These data answer different questions: the threshold says what an individual result must satisfy, while the annual pass rate describes the proportion passing in a group. Do not use the annual percentage as a target score or assume the threshold rises when the rate is lower.
Mock platforms often display “pass” when the total is above their own cut score. Inspect whether their report separately tests the official EAQE minima. If it does not, use it for topic review only. A candidate can create a two-column score note by recording the raw part performance and whether it would meet the EAA threshold, while clearly labeling any conversion as an estimate.
When the result slip arrives, compare the reported Part I and Part II marks to the published minima separately. If a score is unexpectedly close, first verify that the correct part and candidate details appear on the slip. For any concern about an official result, promptly ask PEAK which current procedure applies. Do not rely on an old web snippet for a recheck price or assume an informal question pauses a deadline.
A clear result note can read: Part I, marks earned out of 60, threshold 36; Part II, marks earned out of 40, threshold 24; same-sitting condition met or not met. This compact layout prevents an overall percentage from obscuring a weak part. Use the same structure for timed practice and the official slip.